NASA-Ames Research Center - TP3 Arc Heater Job 1231.00
The Ames TP3 heater is an Arc heater which was relocated fro...read more »m Johnson Space Center, Houston, Texas to the Arc Jet complex, Aerodynamic Heating Facility (AHF) test bay at Ames Research Center in Moffett Field, California. This facility has been the R&D testing facility for tiles which have been used on space re-entry vehicles (shuttle).
ArcSine Engineering designed power distribution, motor controls, and hardwired safety relay logic for the Argon, nitrogen, oxygen, and CO2 gas systems, ventilation and exhaust systems of the test bay, test chamber, and basement area. ArcSine also performed all associated programming of the PLC and HMI screen development. « read less
Napa Sanitation District - Aerator Addition Job 1266.00
Planning and design of aeration system for 100 acre treatmen...read more »t pond system. Included integration with plant control system. Electrical loads were separated by 12-KV overhead distribution and 12-KV to 480-volt unit substation sized for this project as well as permanent sludge dredge and conveyance system. « read less
Dublin San Ramon Services District (DSRSD) SCADA Job 1324.00
Design of a replacement Supervisory and Data Acquisition ...read more »(SCADA) System for the Dublin San Ramon Services District (DSRSD) in Dublin, California. Project elements include inventory of existing system, preparation of SCADA design standards, communications system evaluation and design, preliminary and final engineering design, bid phase assistance, construction engineering services and construction management. « read less
Construction management and observation, and engineering ser...read more »vices during construction for a $4.5 million upgrade to the Dublin San Ramon Service District's (DSRSD) Field Operations Division Supervisory Control and Data Acquisition (SCADA) System covering 47 remote sites. On-site construction management over 80-week project duration, including site inspections, contractor coordination, scheduling, permit coordination, and related construction management services. « read less
In support of discharge permit renegotiations, extracted ...read more »and analyzed 40 million historic data points using the plant's supervisory control and data acquisition historian. Provided evidence that certain key analytical valves have stayed within target ranges, assisted the City in negotiations with the Regional Board, in pursuit of avoiding millions of dollars in plant improvements which otherwise would have been required. « read less
City of Red Bluff - Design-Build SCADA RFQ Solicitation Job 1431.00
Multi-year, on-call contract to provide electrical, mechanic...read more »al, I&C, and SCADA consultation services. Intitial tasks included: Calculations for replacement HVAC system at City Hall, Load calculations and cost estimating for upgrading standby generator system at City Hall/Fire Station, Field investigations and preparation of RFQ solicitation for design-build SCADA replacement contract, Procurement, configuration, and installation of replacement 450MHz licensed SCADA radios. « read less
Yuba City Wastewater Treatment Facility Improvements Job 1512.00
On-call task order contract for ongoing engineering support ...read more »at an in-service wastewater treatment facility. Work included design of: high purity oxygen generation system, new secondary clarifier, rehabilitation of three existing clarifiers, new digested sludge dewatering facility, and a facility-wide evaluation of electrical power distribution and instrumentation/controls systems. « read less
Provided assistance with Wastewater National Pollutant Disch...read more »arge Elimination System (NPDES) permit compliance and program administration services. « read less
Design, procurement, programming, testing, and commissioning...read more » of a replacement Supervisory Control and Data Acquisition (SCADA) system at Iron Mountain Mines, a US EPA Superfund Site located near Redding, California. Replacement system consists of redundant, geographically separated servers, and three operator workstations operating Wonderware Version 2014R2, with inter-server fiber backbone. Programming/configuration consisted of development of +/-90 graphics screens as well as integration with site GIS and CMMS programming. « read less
Northern California & Oregon Engineering Company serving Redding, the Bay Area, and the surrounding Northern California area, as well as Medford, Rogue Valley, Willamette Valley, Southern Oregon, Central Oregon, Nevada, Washington, Idaho, Utah, and Arizona.